Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.8mm
Documente tehnice (Imaginile sunt cu titlu informativ. Va rugam sa consultati specificatiile tehnice.)
Specificatii
Marca
UltimakerProduct Type
Nozzle
Nozzle Material
Brass
Utilizare cu
Olsson Block, Ultimaker 2+
Nozzle Size
0.8mm
Tara de origine
Netherlands
Detalii produs
Ultimaker 2 Jet Nozzles
The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.
With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.
Ultimaker Accessories
€ 32,88
€ 32,88 Buc. (fara TVA)
€ 39,78
€ 39,78 Buc. (cu TVA)
1
€ 32,88
€ 32,88 Buc. (fara TVA)
€ 39,78
€ 39,78 Buc. (cu TVA)
Informatii despre stoc temporar indisponibile
1
Informatii despre stoc temporar indisponibile
Documente tehnice (Imaginile sunt cu titlu informativ. Va rugam sa consultati specificatiile tehnice.)
Specificatii
Marca
UltimakerProduct Type
Nozzle
Nozzle Material
Brass
Utilizare cu
Olsson Block, Ultimaker 2+
Nozzle Size
0.8mm
Tara de origine
Netherlands
Detalii produs
Ultimaker 2 Jet Nozzles
The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.
With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.