Documente tehnice
Specificatii
Marca
TridonicPrimary Voltage Rating
230 → 240V ac/dc
Secondary Voltage Rating
11.8V
Dimensiuni
207 x 46 x 40 mm
Lungime
207 mm
Latime
46 mm
Adancime
40 mm
Minimum Load Requirement
50VA
Temperatura minima
-25°C
Maximum Temperature
+50°C
Greutate
290 g
Tip produs
Electronic
Dimming
Dimming
Dimming Method
Trailing Edge
Minimum Operating Frequency
50Hz
Protectii
Short Circuit Shutdown
Efficiency
0.95
Maximum Operating Frequency
60Hz
Detalii produs
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Informatii indisponibile despre stoc
Incercati din nou mai tarziu
P.O.A.
1
P.O.A.
1
Documente tehnice
Specificatii
Marca
TridonicPrimary Voltage Rating
230 → 240V ac/dc
Secondary Voltage Rating
11.8V
Dimensiuni
207 x 46 x 40 mm
Lungime
207 mm
Latime
46 mm
Adancime
40 mm
Minimum Load Requirement
50VA
Temperatura minima
-25°C
Maximum Temperature
+50°C
Greutate
290 g
Tip produs
Electronic
Dimming
Dimming
Dimming Method
Trailing Edge
Minimum Operating Frequency
50Hz
Protectii
Short Circuit Shutdown
Efficiency
0.95
Maximum Operating Frequency
60Hz
Detalii produs
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.