RS PRO Process Pump Controller for Brushless Micropump, 6/28 V
Documente tehnice (Imaginile sunt cu titlu informativ. Va rugam sa consultati specificatiile tehnice.)
Specificatii
Marca
RS ProCompatible Pump Type
Brushless Micropump
Product Type
Process Pump Controller
Tensiunea de alimentare
6/28 V
Protectie IP
IP20
Maximum Output Pressure
10bar
Standards/Approvals
No
Tara de origine
United Kingdom
Detalii produs
Brushless Micro Pump Controller
A compact and highly efficient motor controller for the RS Pro range of centrifugal micro-pumps.
The EQi controller accepts and input voltage of up to 30 volts and pump speed can be controlled from a potentiometer on the board or via a 0-5v external signal. With voltages above 12v the controller works to maintain a constant flow despite the increase in back pressure helping to provide a flatter flow – pressure curve.
Installation is easy, simply wire the two input terminals, attach the three outputs to the micro-pump and set the jumper position for on board speed control or control via an external 0-5v signal.
Informatii despre stoc temporar indisponibile
€ 91,98
€ 91,98 Buc. (fara TVA)
€ 111,30
€ 111,30 Buc. (cu TVA)
1
€ 91,98
€ 91,98 Buc. (fara TVA)
€ 111,30
€ 111,30 Buc. (cu TVA)
Informatii despre stoc temporar indisponibile
1
Documente tehnice (Imaginile sunt cu titlu informativ. Va rugam sa consultati specificatiile tehnice.)
Specificatii
Marca
RS ProCompatible Pump Type
Brushless Micropump
Product Type
Process Pump Controller
Tensiunea de alimentare
6/28 V
Protectie IP
IP20
Maximum Output Pressure
10bar
Standards/Approvals
No
Tara de origine
United Kingdom
Detalii produs
Brushless Micro Pump Controller
A compact and highly efficient motor controller for the RS Pro range of centrifugal micro-pumps.
The EQi controller accepts and input voltage of up to 30 volts and pump speed can be controlled from a potentiometer on the board or via a 0-5v external signal. With voltages above 12v the controller works to maintain a constant flow despite the increase in back pressure helping to provide a flatter flow – pressure curve.
Installation is easy, simply wire the two input terminals, attach the three outputs to the micro-pump and set the jumper position for on board speed control or control via an external 0-5v signal.