Kübler K 07.20 Counter, 7 Digit
Documente tehnice
Specificatii
Marca
KüblerCount Mode
Impulses
Functie
Counter
Input Type
Voltage
Tip conexiune
Solder Pin
Reset Method
No Reset
Number Of Digits
7
Timp montare
Panel Mount
Output / Interface
Voltage
Count Direction
Up
Digit Height
4 mm
Cutout Size
30 x 13 mm
Temperatura minima de lucru
-10°C
Minimum Measurement
0
Cutout Height
15mm
Serie
K 07.20
Cutout Width
35mm
Adancime
32.7mm
Measurement Range
0 → 9999999
Meter Type
Electromechanical
Approvals
cULus, RoHS, UL
Temperatura maxima de lucru
+60°C
Tara de origine
Germany
Detalii produs
Type K07 - micro cumulative counter, 7-digit, front panel mounting
PCB, Surface & DIN Rail Mounting
All units are non-resettable and are continuously rated,Counters may be damaged if connected to inductive loads where high voltage transients may be present. Should this be unavoidable, use a suitable suppression circuit (refer to the Capacitors section) connected across the count or reset coil terminals.,Count rate of all products is 10Hz.
€ 38,61
€ 38,61 Buc. (fara TVA)
€ 45,95
€ 45,95 Buc. (cu TVA)
1
€ 38,61
€ 38,61 Buc. (fara TVA)
€ 45,95
€ 45,95 Buc. (cu TVA)
1
Informatii despre stoc temporar indisponibile
Incercati din nou mai tarziu
| Cantitate | Pret unitar |
|---|---|
| 1 - 4 | € 38,61 |
| 5 - 9 | € 37,08 |
| 10+ | € 35,22 |
Documente tehnice
Specificatii
Marca
KüblerCount Mode
Impulses
Functie
Counter
Input Type
Voltage
Tip conexiune
Solder Pin
Reset Method
No Reset
Number Of Digits
7
Timp montare
Panel Mount
Output / Interface
Voltage
Count Direction
Up
Digit Height
4 mm
Cutout Size
30 x 13 mm
Temperatura minima de lucru
-10°C
Minimum Measurement
0
Cutout Height
15mm
Serie
K 07.20
Cutout Width
35mm
Adancime
32.7mm
Measurement Range
0 → 9999999
Meter Type
Electromechanical
Approvals
cULus, RoHS, UL
Temperatura maxima de lucru
+60°C
Tara de origine
Germany
Detalii produs
Type K07 - micro cumulative counter, 7-digit, front panel mounting
PCB, Surface & DIN Rail Mounting
All units are non-resettable and are continuously rated,Counters may be damaged if connected to inductive loads where high voltage transients may be present. Should this be unavoidable, use a suitable suppression circuit (refer to the Capacitors section) connected across the count or reset coil terminals.,Count rate of all products is 10Hz.