Kübler K 07.20 Counter Counter, 7 Digit
Documente tehnice
Specificatii
Marca
KüblerCount Mode
Impulses
Input Type
Voltage
Tip conexiune
Solder Pin
Reset Method
No Reset
Number Of Digits
7
Montare
Panel Mount
Output / Interface
Voltage
Count Direction
Up
Digit Height
4 mm
Functie
Counter
Cutout Size
30 x 13 mm
Measurement Range
0 → 9999999
Frecventa minima de auto-rezonanta
-10°C
Minimum Measurement
0
Cutout Height
15mm
Serie
K 07.20
Cutout Width
35mm
Adancime
32.7mm
Meter Type
Electromechanical
Approvals
cULus, RoHS, UL
Temperatura maxima de lucru
+60°C
Tara de origine
Germany
Detalii produs
Type K07 - micro cumulative counter, 7-digit, front panel mounting
PCB, Surface & DIN Rail Mounting
All units are non-resettable and are continuously rated,Counters may be damaged if connected to inductive loads where high voltage transients may be present. Should this be unavoidable, use a suitable suppression circuit (refer to the Capacitors section) connected across the count or reset coil terminals.,Count rate of all products is 10Hz.
Informatii indisponibile despre stoc
Incercati din nou mai tarziu
€ 40,72
Buc. (fara TVA)
€ 48,46
Buc. (cu TVA)
1
€ 40,72
Buc. (fara TVA)
€ 48,46
Buc. (cu TVA)
1
Cumpara in pachete mari
| Cantitate | Pret unitar |
|---|---|
| 1 - 4 | € 40,72 |
| 5 - 9 | € 38,14 |
| 10+ | € 36,30 |
Documente tehnice
Specificatii
Marca
KüblerCount Mode
Impulses
Input Type
Voltage
Tip conexiune
Solder Pin
Reset Method
No Reset
Number Of Digits
7
Montare
Panel Mount
Output / Interface
Voltage
Count Direction
Up
Digit Height
4 mm
Functie
Counter
Cutout Size
30 x 13 mm
Measurement Range
0 → 9999999
Frecventa minima de auto-rezonanta
-10°C
Minimum Measurement
0
Cutout Height
15mm
Serie
K 07.20
Cutout Width
35mm
Adancime
32.7mm
Meter Type
Electromechanical
Approvals
cULus, RoHS, UL
Temperatura maxima de lucru
+60°C
Tara de origine
Germany
Detalii produs
Type K07 - micro cumulative counter, 7-digit, front panel mounting
PCB, Surface & DIN Rail Mounting
All units are non-resettable and are continuously rated,Counters may be damaged if connected to inductive loads where high voltage transients may be present. Should this be unavoidable, use a suitable suppression circuit (refer to the Capacitors section) connected across the count or reset coil terminals.,Count rate of all products is 10Hz.